top of page
TPro Panel Filters
TPro Panel filters are fully fabricated in 316 Stainless Steel and are designed to be dismantled to replace the "pleat pack"
The top and bottom are held together by 1/8 (3.2mm) x 8mm aluminium Rivets that should be ground off.
Alternatively, a sharp tap with a hammer on a block of wood immediately adjacent to a rivet will cause it to shear. Care should be exercised if trying this method however.
Once the top and bottom have been separated the pleat pack can be replaced.
Further information on these and Marne Turbocharger filters can be found on our website here:
How to replace Filter Pleats
Important: The supporting plastic mesh must be on the clean or "down stream" side of the filter ie: inside the vessel
Inserting 1/8 (3.2mm) Rivets
bottom of page